Little bug in the JoyPads in 5.14

luizthiago

Good morning friends.

I have another question regarding controls.

After I upgraded my batocera to 5.14 on raspberry Pi 3, I'm having a little bug in the controls on certain screens like:

Configuration of the control in Kodi
Retroarch menu

The bug is as follows:

In these screens, when I press a button, for example "down", it is being detected twice doubly, that is, I press once down and two options are deviated below and not only one ....

I would like to know if anyone else had this problem too, on this platform ....

My control is generic to PS3 and is recognized as PS3 CONTROLLER (PlayStation R) PANHAI.

If anyone can help, I'm grateful!

nadenislamarre

strange.
from which version did you upgrade ?
is your pad configured on batocera ?

luizthiago

nadenislamarre yes .... the pad is the same i use until the version 5.10 ...

I'm upgrade from 5.13 officially, to 5.14 oficially too !

Strange, but in games, this problem does not ocurring ...it's indicate has no problem with my pads ...only in these screens it occurs

luizthiago

this problem occurs in PSX games , while in "Retroarch Menu" ...quick options >>>

Someone experienced the same problem ?

michel83

I have the same problem on the pi3 and xu4. During setting up the controller, when I get to L2, it jumps directly to R3 or L3. I have to repeat several times to press the analog buttons (L2 R2 L3 R3) to get the right value. For my controller, I need positive values for L2 and R2. With negative values, the retroarch menu and some games (ex: colin mcrae on PSX) work poorly or not (inverted commands)

joinski

michel83

look here:
https://batocera-linux.xorhub.com/forum/d/1144-joystick-configured-out-of-the-box

luizthiago

michel83 batocera has bugs in 5.14 again ! .... 🙁

I Experienced the same bugs here !...

in 5.13 all works fine regarding Pads..but in 5.14 ...Various bugs !

joinski

I had the issue with joypads already in 5.13 (and i think in 5.12 also).
But i did not update from 5.11, i always do a fresh install on a new USB-Stick.

luizthiago

joinski i Aways update the system ...because install a fresh in all updates is boring....

In my case, i Use raspberry Pi3 ...

joinski

Ok, i mainly use x86 hardware, but i also own Pi2 and Pi3

luizthiago

Bug solved !

I Reconfigured my Pads in ES and now, It's OK ....

Thanks all for help !