Activation of N64 rumble

chris256

Hello everyone!

I would like to have rumble with my xbox 360 gamepad for N64 games. It works out of the box for dreamcast but not for N64. I tried to change the lines
Mempak switch = Rumblepak switch =
inInputAutoCfg.ini file but it does not work. In fact, when I launch a n64 game this file is reset to default. Any suggestion? Did someone make it work?

And also does someone know how to change the deadzone for the analog stick?

Thanks!!

PS: does someone know what is the number for L3 and R3 buttons as I would like to use them as switches.

chris256

Hello everyone!

Could someone please help me with he configuration of the N64 gamepad as described above?

Thanks for your help!

chris256

Hello!
I found the solution so I share. What you have to do is:
1) Launch at least a N64 game with your gamepad connected
2) edit the file in share/system/config/mupen64 that is called mupen64plus.cfg (you can use the BATOCERA network drive on your local network)
3) Go to section [Input-SDL-Control1]
4) Change mode = 2 to mode = 0
5) Change Mempak switch = "" to Mempak switch = button(9)" (in case of an xbox360 controller, thus corresponds to L3 button)
6) Change Rumblepak switch = "" to Rumblepak switch = "button(10)" (in case of an xbox360 controller, thus corresponds to R3 button)
7) You can also change AnalogDeadzone = "4096,4096" (in my case, the pointer in games was slowly moving without that)
8) Save and exit file
9) Launch a game
10) Press R3 button (analog right stick button) to activate rumble (and L3 if needed to go back to memory extension pack)
11) Enjoy ;-)

My mistake was step 4) previously...

Hope this helps!