Install went fine through PINN (using the boot image). Haven't had much time testing, just populated some systems and tried to configure some Shader Sets per system in advanced settings and noticed that the shader settings per system don't get saved and switch back to "Auto" every time. The overall shader settings work, just not on a per system based level.
Also, thebezelproject doesn't display any bezel if no bezel is found instead of the default one.
Will test more over the weekend! Looking real good so far!
add: is there a way to set the unglazed bezel as default for system deco for screensaver (mame uses glazed one)? (minor cosmetic preference :)
ok, just tried to use update with today's beta build and on reboot the screen stays black. had to go into PINN and reapply the partition layout for it t boot up again, something about invalid FAT ID.
Here's the partition info I use with PINN when installing: https://github.com/matthuisman/pinn-os/blob/master/batocera_RPi4/partitions.json in case it's a PINN issue, I don't know.