Hi all,
I did my best to research this but there doesn’t seem to be any solid answer, and the ones I have found haven’t worked for me.
I am trying to map an N64 controller in batocera and I can’t seem to figure out how to do it where it works with emulationstation and also has the correct buttons in roms. Honestly even just getting the correct mapping within roms is very difficult and I have had limited success.
Does anyone have a better fix for this? Or perhaps even a recommendation on mapping from within a config file? Sorry if this is a common issue but I had no luck searching the forum for a pre-existing thread and from what I found on google there were only fixes documented for retropie and recalbox.
thanks!!!
My setup is:
Dell optiplex 3010
intel i5 3570
intel graphics
8gb ram
Hyperkin N64 usb adapter
