I have a problem with batocera and my new RPi4. Batocera stay on boot logo and don’t launching…
What I did :
- I downloaded the last official version (and I tried the beta version too)
- I installed it with etcher,
- I configured the file for add
sdtv_mode=0 for use it on my CRT screen.
When I put the SD card in the RPi4, Batocera launch and stay on the Batocera’s logo… And nothing happen…
I waited 45 minutes on boot logo (just in case), but nothing happened…. I only see the boot logo.
Before, I used Recalb°x. So, I tried to use their last version on the RPi4 (same configuration with
sdtv_mode=0) and all work fine… So , the RPi4 is OK…
But I don’t want use Recalb°x on my RPi4… I prefer Batocera.
Did I do something wrong ? Did I miss something ?
Thank you for your help.
Edit : I use composite exit and VGA cable