Batocera 33 does not boot beyond splash RPi4

moezone

Batocera 33 has a problem with RPi4 overclocking. whatever values I put it just displays a blank screen after the splash with no signal. I tried the built in boost and manualy editing config.txt but no use.

It wont get in before commenting the freq and voltage…

I tried multiple microsd cards, multple hdmi cables, both ports, every freq, disconnecting any usb, and still does not go beyond splash screen

Does anyone have the same issue

Atari

Works fine on my pi, maybe you have an insufficient power supply for overclocking?
You can always insert the SD card into a computer and comment out the overclocking values.

D0min8t0R

Have you tried updating your RPi4 firmware?

tomissb

Same here.