Anyone have a good solution?
I bought two lightguns. I used one (most likely original firmware, not sure if 1.3) on an older Batocera PC setup, upgraded Batocera to V36 and the gun worked fine.
I got an img of a Batocera v35 setup. Like lot of members, the crosshair is stuck on the upper left corner. Upgraded to v36, same issue. Upgrade lightgun to fw 1.8 from 1.6, back to 1.3, back to 1.8, lightgun recognized after unplugging and plugging back in with all the fw but crosshair still stuck on upper left corner.
tried to figure out “pressed F1, went to applications, started a terminal. I cd’d to the /var/run/sinden dir.” didnt know what to add/change on the config file….