mussolla I’ve 2 8Bitdo Pro 2 Wired controllers, but they aren’t detected by my batocera v35 (PC). Has anybody been throught anything like it? Or does anyone have some advice about what could I try?
abaaihd mussolla On v35 for me it worked in direct input Mode. Yes, the wiki says x-input but… Just one tip. If you’re planning to update on v36 and want to use cemu with that controller wait a while. There’s currently an issue with mapping the buttons in cemu.
resadent This is normal as kernel 5.18 does not have support for this device. You will need to wait for batocera to release a stable version with newer kernel or perhaps try latest beta, which I assume must have a recent enough kernel (support for this device was added in september 22).
jase great,thanks for the reply. I was sure I read that someone had it configured but I obviously miss read.. It;s a great controller so ill be content to use it wired till its updated. Cheers
SSThing Jase, may I ask, are your controllers the wired version or the Bluetooth version but connected with usb? If it’s the bt version, did you have to do anything other than connect the USB to get all the buttons to work correctly?
