Hello, is the wireless adapter not working on Batocera V31? Below capture dmesg when I tried to change to other usb port on my PC:

[10451.206549] usb 3-4: USB disconnect, device number 3

[10469.154522] usb 1-9: new high-speed USB device number 5 using xhci_hcd

[10469.389005] usb 1-9: New USB device found, idVendor=045e, idProduct=02e6, bcdDevice= 1.00

[10469.389006] usb 1-9: New USB device strings: Mfr=1, Product=2, SerialNumber=3

[10469.389007] usb 1-9: Product: XBOX ACC

[10469.389008] usb 1-9: Manufacturer: Microsoft Inc.

[10469.389009] usb 1-9: SerialNumber: 222593

[10469.623656] usb 1-9: reset high-speed USB device number 5 using xhci_hcd

[10469.855001] mt76×2u 1-9:1.0: ASIC revision: 76320044

[10470.438734] mt76×2u 1-9:1.0: ROM patch build: 20141115060606a

[10470.759875] mt76×2u 1-9:1.0: Firmware Version: 0.0.00

[10470.759876] mt76×2u 1-9:1.0: Build: 1

[10470.759877] mt76×2u 1-9:1.0: Build Time: 201507311614____

[10473.153050] mt76×2u 1-9:1.0: error: MCU resp evt:9 seq:1-0

[10473.153090] mt76×2u 1-9:1.0: error: MCU resp evt:9 seq:1-0

[10473.153131] mt76×2u 1-9:1.0: error: MCU resp evt:9 seq:1-0

[10473.938033] ieee80211 phy2: Selected rate control algorithm ‘minstrel_ht’

[10474.446987] usb 1-9: reset high-speed USB device number 5 using xhci_hcd

[10474.866981] usb 1-9: reset high-speed USB device number 5 using xhci_hcd

[10475.097957] mt76×2u 1-9:1.0: ASIC revision: 76320044

[10475.682961] mt76×2u 1-9:1.0: ROM patch already applied

[10475.682975] mt76×2u 1-9:1.0: loading /lib/firmware/mt7662.bin failed with error -4

[10475.682976] mt76×2u 1-9:1.0: Direct firmware load for mt7662.bin failed with error -4

Thanks & regards,